Welcome To Mech Spares Private Limited

Designing Components

The following should be borne in mind at the design stage:

  • Be aware of where the split line will fall
  • Think about removing the part from the mould when it is hot and soft
  • Rubber parts do not generally need taper
  • Re-entrant shapes are practical in rubber
  • Core out thick sections which would extend cure times
  • Geometric shapes make for economic tools
  • Combine features – such as seals, springs, logos and tolerance take-up – from other parts.

Member Testimonials

© Mech Spares Pvt. Ltd. All rights reserved.

Website Design by EWEBAC